PWM driving of high-power LED with an arduino - LEDs and
I need to drive 2 red and 2 blue high-power LEDs for an application (LED indicated below). First of all, I connected the LEDs directly to the 12V power supply and measured the currents they draw. As you can see, the red one draws about 1.4A. As you can see, the blue one draws about 0.5A. My question is that I want to use MOSFET to drive these LEDs with PWM, I have shared two circuits below which should I use?Why? Circuit-1 Circuit-2
How to Control LEDs on the Arduino - Circuit Basics
Can someone explain why do I need a MOSFET and a resistor to change the brightness of a strip led? - General Electronics - Arduino Forum
Arduino-based High Powered Switching LED Drivers : 5 Steps - Instructables
Not able to generate different voltages from Arduino PWM & MOSFET - General Electronics - Arduino Forum
For all of you out there who want to control 12 channels of PWM, we salute you! We also would like you to check out this breakout board for the
Adafruit 12-Channel 16-bit PWM LED Driver - SPI Interface
Constant current LED driver with arduino pwm - Project Guidance - Arduino Forum
Arduino compatible coding 08: Interfacing an RGB LED using Arduino
Using LED Drivers with Dimming Control by Arduino
Interfacing RGB Led with Arduino
high power led driver - LEDs and Multiplexing - Arduino Forum
PWM input with 5V/5A-8.5A - Project Guidance - Arduino Forum